drum rider

Drums + Electronics Rider - Christian Thomé  

attention:

- all top heads must be white-coated Remo Ambassador. Bottom heads can be either white-coated or transparent Remo Ambassador. Both heads of bassdrum must be white-coated Remo Ambassador, no muffled heads! Fronthead of bassdrum must be without a hole.

- I need two snaredrum stands that go very low

Good, acoustic jazz drumset, Gretsch, Sonor Lite, Canopus, Yamaha Maple Custom or similar:

 

Drums:

1x bass drum (20" or 18")

1x snare drum (14"x5" - max. 7") preferable w/ die cast rims

1x tomtom (10" or 12", also 8") (to go on an extra snare drum stand)

1x floor tom (14" or 16") with legs, no hanging tom

all required stands and parts

Hardware:

2x snare drum stands that go very low

4x cymbal stands, preferable thin and light versions

1x drum seat

1x bass drum pedal, mallet with whole felt

1x hihat stand w/ moveable pedal or legs

1 rug (3m x 2m)

Drumheads:

all top heads must be white-coated Remo Ambassador or similar. Bottom heads can be either white-coated or transparent Remo Ambassador. no pinstripes or other muffled heads! no hole or muffled heads on the bass drum!

no cymbals required

Electronics:

2 DI Boxes, triple powerpoint, a table or box to place the electronic rack on: ca. 50 x 50, H 60-80 cm

1 cable (XLR or Jack) w/ the monitor signal instead of a monitor box, to be plugged in my headphone mixer

Microphones (if needed)

all microphones must be on stands and not clips!

overheads: Neumann KM84, AKG C414 or sim.

bass drum front head: Electro Voice RE 20, AKG D12 or sim.

snare drum: Shure SM 57